How to make the laser cutting machine have a good cutting state?

Although the working efficiency of thelaser cutting machinehas always been recognized by everyone, when we use it, we hope that the cutting speed of the laser cutting machine will be faster the cutting effect will be better.But what should we do to get the effect we want?Let the editor tell everyone.

Man has a good body works with energy.The same goes for the machine, which can only run smoothly if it is in good condition.This requires our daily maintenance.

First, debug laser cutting machine parameters maintain machine cutting speed.

Machine parameter setting is one of the main reasons that affect the cutting speed of the laser cutting machine.In general, if the parameters are adjusted well, its cutting speed will work.The parameters are like a series of related actions such as people driving, starting, accelerating, etc. If the parameters are set properly, it is like when the car is starting, you hang a second gear to start, which leads to when starting, It will jitter.Therefore, when adjusting this parameter, you should pay attention to the following two places:

1. Initial speed: As the name suggests, this setting is the speed at which the machine starts, like the speed at which the car has just started in the process of driving.Many customers have such misunderstandings, thinking that the greater the initial speed, the better, but in fact this is wrong.If the initial speed of the laser machine is set too high, the machine jitter will be very large.

2. Acceleration: Acceleration means the speed of the throttle during the driving of the car. It is the time it takes the initial speed to the normal cutting of the machine.Laser cutting machine is a process of continuous start stop when cutting different patterns. If the acceleration is set too low, the machine will cut slowly.

Second, adjust the machine assembly to make the laser cutting machine cut fast, accurate, stable beautiful.

1. Guide rail installation: The guide rail installation should be parallel. If the installation is parallel, the machine will have resistance when running, it will be stuck when walking. The laser cutting machine will have saw teeth when it is cut.Therefore, the installation of the two guide rails in the Y direction should be two parallel lines, there must be no error between them.

Laser cutting machine guide

2. The installation position of the beam the coupling is good.When the machine beam the coupling are installed, the screw is locked, the lock is inclined, etc., it will happen.

Therefore, in the daily use process, we can maintain the laser cutting machine properly to achieve the ideal cutting state.

If you follow the above method in your daily life, you can make the working effect of the laser cutting machine reach your ideal state, I hope to help everyone.